+ Reply to Thread
Results 1 to 5 of 5
Thread: Driver Shaft to 3 wood
-
07-04-2021 05:14 PM #1
Driver Shaft to 3 wood
I have a Tour AD DI 7S with a 910 driver adapter. Luckily the adapter fits the 910f too. Is it as simple as removing the tip, cutting 1/2” off the tip and then butt trim to length?
-
07-04-2021 09:46 PM #2
Yep, that's it.
Not fat anymore. Need to get better at golf now!
-
07-05-2021 06:37 AM #3
Always a good idea to check the trimming instructions as some shafts are butt trimming only. From the following it looks as though you're OK
https://proschoicegolfshafts.com/pdf-trimming-guide/
See the note at the bottom of the trimming guide.Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
07-05-2021 11:57 AM #4
Thanks. That’s the guide I was checking too. With following that guide for trimming, it shouldn’t stiffen the shaft because the 3 wood head is heavier, right?
-
07-05-2021 01:33 PM #5
Correct. There usually is a 10 gram difference between the 2
Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Driver shaft in a 3-wood?
By nokids in forum Club Making & ComponentsReplies: 2Last Post: 07-24-2013, 12:09 PM -
Driver Shaft vs. 3 Wood Shaft
By quinner in forum Club Making & ComponentsReplies: 1Last Post: 06-16-2010, 01:09 PM -
Would a wood shaft be the same as a driver shaft (fitting)
By sillywilly in forum Club Making & ComponentsReplies: 5Last Post: 05-27-2008, 12:10 PM -
Driver shaft in a 3 wood?
By northern33 in forum Club Making & ComponentsReplies: 13Last Post: 09-25-2006, 10:00 PM -
Driver/Fairway wood shaft
By mcgoo in forum Components & ToolsReplies: 0Last Post: 04-15-2006, 06:31 PM