Tip weight

[slash]

Looking for a 454 tip weight that goes on a frequently analyser

[Chieflongtee]

Hate to be the bearer of bad news but you don’t need one. It’s only needed for zone profiling especially
down to 11 inches from the tip. You would need the clamp that tapers off to accomodate the tip diameter and a frequency
meter that goes up to 999 cpms. To find out more see tech note #36
https://www.csfa.com/technote36.php


The good news is if you want to do shaft profiling with your machine you can use the method shown below:
https://store-k9nvqai7wz.mybigcommer...ons/MA2014.pdf

Hope that helps

[slash]

Merci le (chef)