CorporateGolfXtra 2024
+ Reply to Thread
Results 1 to 1 of 1

Thread: Spine and flo

  1. #1
    Need a Caddy slash is on a distinguished road
    Join Date
    May 2010

    Spine and flo

    Is the spine finder just a quick way to start with the flo. Took my shafts off since not golfing at the moment. Found the spine,a hump i would call it and marked it ai 12 oclock.I assume that would be the stiffest part 12/6. Then proceed to flo moving that line to 3 o'clock since I am a lefty. The NBP would be on the 3/9. I might not understand it completely since if the spine (hump) is on top, the shaft wants to to right or left. Would the right or left be the NBP.Was thinking that if the spine is on top and install it that way in my iron it would be in it's natural bending motion.When I flo them except for one that flows perfectly in that position all others were perfectly flowed at the 3 o'clock.
    Last edited by slash; 05-22-2020 at 03:40 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)


Similar Threads

  1. The Spine Finder
    By leftylucas in forum Components & Tools
    Replies: 2
    Last Post: 04-27-2020, 05:56 PM
  2. Spine finder
    By leftylucas in forum Components & Tools
    Replies: 1
    Last Post: 02-05-2020, 09:35 AM
  3. Spine alignment; What if ????
    By downhillslider in forum Golf Clubs
    Replies: 16
    Last Post: 08-12-2006, 03:41 PM
  4. Spine definition
    By Chieflongtee in forum Club Making & Components
    Replies: 8
    Last Post: 07-23-2005, 11:09 PM
  5. Spine and FLO plane
    By byerxa in forum Club Making & Components
    Replies: 4
    Last Post: 12-30-2004, 05:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts