I have a Tour AD DI 7S with a 910 driver adapter. Luckily the adapter fits the 910f too. Is it as simple as removing the tip, cutting 1/2” off the tip and then butt trim to length?
Printable View
I have a Tour AD DI 7S with a 910 driver adapter. Luckily the adapter fits the 910f too. Is it as simple as removing the tip, cutting 1/2” off the tip and then butt trim to length?
Yep, that's it.
Always a good idea to check the trimming instructions as some shafts are butt trimming only. From the following it looks as though you're OK
https://proschoicegolfshafts.com/pdf-trimming-guide/
See the note at the bottom of the trimming guide.
Thanks. That’s the guide I was checking too. With following that guide for trimming, it shouldn’t stiffen the shaft because the 3 wood head is heavier, right?
Correct. There usually is a 10 gram difference between the 2