+ Reply to Thread
Results 1 to 2 of 2
-
06-22-2007 05:05 PM #1
Putting a ferrule back in its place
Here is an easy way to put back a loose ferrule in its place. If you ever change your spikes you can use the same tool tool in a vise. After roughening up the shaft where the ferrule originally was ,mix up a bit of 5 minute epoxy.Then heat the ferrule with a heat gun for no more than 5 seconds or use boiling water. Then put the club in the tool and pull towards you. Et Voilà problem fixed. Sounds like a Farm Boy recipe
Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
06-22-2007 06:41 PM #2
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
GC2 on its way,putting pieces in place,suggestions welcomed
By shoot4one in forum Home Simulators - GeneralReplies: 26Last Post: 04-01-2012, 08:01 PM -
Ferrule for TM irons
By davevandyk in forum Club Making & ComponentsReplies: 1Last Post: 03-19-2012, 12:45 PM -
Putting holds Woods back at Players Championship
By Kilroy in forum Tour TalkReplies: 0Last Post: 05-08-2009, 06:20 AM -
What is prepping and what is a ferrule
By "Richard" in forum Club Making & ComponentsReplies: 6Last Post: 04-19-2006, 09:08 PM -
Back Yard Putting Green
By Kbulm in forum General Golf TalkReplies: 23Last Post: 10-02-2004, 10:52 AM