Results 1 to 7 of 7
Thread: Soft stepping.....
Threaded View
-
09-16-2018 03:16 PM #1
Soft stepping.....
Usually done as a single step .... 5i shaft into a 6i head etc. Can a dble step be done .... 5i shaft into a 7i head ?? Wasting the shaft ?? Actually I am taking a set of shafts from blind bore heads and wanting to install some of them into a partial set of bore through Callaways. Thus the dble step to get the desired length. Flex seems to measure ok. Has any fitter done this to set of heads and shafts ??
Thanks for any comments.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Rifle 6.0 FCm and Soft Stepping?
By Break68 in forum Club Making & ComponentsReplies: 6Last Post: 05-14-2014, 08:57 AM -
Soft/Hard Stepping
By Big Johnny69 in forum Club Making & ComponentsReplies: 8Last Post: 11-02-2008, 08:22 AM -
Annika stepping away, for now
By Kilroy in forum Tour TalkReplies: 0Last Post: 10-23-2008, 10:50 AM -
Soft stepping FST iron shafts
By rhh7 in forum Club Making & ComponentsReplies: 8Last Post: 12-26-2006, 06:58 PM -
Soft and Hard stepping
By sammypvt in forum Club Making & ComponentsReplies: 25Last Post: 12-01-2006, 08:53 AM