Hi at all,

Iīm quite new to this forum. I found because I need some helpwith my preowned Vector Pro with manual lenses.

The Power LED is not indicating the operating or charging mode. Also the two green front LEDīs are only sometimes indicating the operating mode.

But the unit will be rocognized by the PC. So I was able to install the drivers and found the two entries Accusport VectorPro in my device manager.

When I start the software the setup wizard wants me to connect the unit allthough it is connected. So the software does not recognize the unit.

Does anyone has got the same problems or any idea to solve the problem?

Thanks for any help.

Regards

Sinner