+ Reply to Thread
Results 1 to 2 of 2
-
09-25-2014 08:34 AM #1
- Join Date
- May 2007
- Location
- ottawa
- Posts
- 1,979
Fitting on an adapter... question...
I am looking to put a Ping after market adapter (CMX adapter) onto a very nice and clean shaft that was pulled from another driver head.
It has a good 1.5" of cleaned, prepped shaft tip, but it seems like the CMX adapter only has a depth of 1.25"...
So my question is, would I be better trimming the tip by 1/4" or would I be better off installing a small ferrule to hide the 1/4" of cleaned shaft that would be exposed?
This is a tip stiff shaft already.
Thanks for your input.
-
09-25-2014 09:44 PM #2
Tipping it 1/4 will make it play a tad stiffer. Leaving the abraded part not covered will not affect playability. Unlike steel it will not rust or deteriorate over time. It is mostly a cosmetic issue.I have installed small ferrules over the adapter in the past just to to hide the extra abraded part. You also have to factor in total length in the equation.
Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Fitting Question
By strongjag in forum Golf ClubsReplies: 9Last Post: 04-23-2015, 03:05 PM -
Ping Fitting Question
By Indygolf in forum Golf ClubsReplies: 5Last Post: 04-07-2014, 09:03 PM -
R1 Fitting Question
By Jimmy3864 in forum Golf ClubsReplies: 1Last Post: 03-14-2013, 08:57 PM -
fitting question
By Drew in forum Club Making & ComponentsReplies: 4Last Post: 01-13-2010, 04:01 PM -
Custom fitting question
By halam in forum InstructionReplies: 0Last Post: 08-18-2004, 10:15 PM