+ Reply to Thread
Results 1 to 3 of 3
Thread: Newbie question
-
05-27-2014 05:50 PM #1
- Join Date
- Dec 2012
- Location
- mentor, ohio
- Posts
- 11
Newbie question
My golf room if just about finally ready (a good month or so later than anticipated). Have a GC2 as the engine. Here's my newbie question. The room is 15 feet wide and the projector will be mounted exactly in the middle of the room. But... because of the 15 foot width, I don't think the hitting area should be exactly in the middle of the room. The backswing could be an issue with the wall only being 7 feet away. So, if I make the hitting area say a foot or so to the right side of the room... how does this affect the software/image of the hole. In other words, if I'm teeing off on the 1st hole, looking down the fairway, won't the fairway image be in the middle of the screen? I feel like I'd be aiming the corresponding amount over to the right. How does this work? Screen size is going to be 8 feet high by 14 feet wide.
-
05-27-2014 07:48 PM #2
- Join Date
- Apr 2011
- Location
- Michigan
- Posts
- 99
I have 7'3" from tee to wall behind right handed swinger. I have several 6'3" friends that play in my system and it has never been an issue in hitting the wall during backswing or follow thru. Mark your 7'6" (center) location and have your tallest friends with drivers over for some swings. If you need to offset LCD I would guess it's just by inches.
-
06-03-2014 04:35 PM #3
- Join Date
- Dec 2011
- Location
- Upstate New York, USA
- Posts
- 114
You tell the GC2 where it is and it will adjust the image for you. Not perfect but you still aim the usual way basically.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Newbie shaft length question
By kaimonica in forum Club Making & ComponentsReplies: 2Last Post: 01-13-2008, 09:29 AM -
Newbie question about club fitting...
By BredStik in forum Golf ClubsReplies: 11Last Post: 02-21-2007, 09:00 PM -
Newbie Question: Changing Loft
By amac in forum Club Making & ComponentsReplies: 6Last Post: 12-08-2004, 01:52 PM -
Newbie with a question/request...
By 5.Point.5 in forum Golf ClubsReplies: 3Last Post: 05-12-2004, 10:58 PM -
Newbie with a question/request...
By 5.Point.5 in forum General Golf TalkReplies: 0Last Post: 05-12-2004, 12:48 AM