+ Reply to Thread
Results 1 to 3 of 3
Thread: Driver shaft in a 3-wood?
-
07-24-2013 12:07 PM #1
Driver shaft in a 3-wood?
I have a Matrix 7m3 black tie stiff shaft and want to put this baby on a Rocketballz 3-wood head. Will this work?
You only get out of something what you put into it
-
07-24-2013 12:08 PM #2
Nevermind, i see there are countless threads at the bottom on this subject lol
You only get out of something what you put into it
-
07-24-2013 12:09 PM #3
In general it shouldn't be an issue.
You just need to trim it according to the instructions for a 3W. You might need to adjust for the RBZ adapter and you'd need to know what trimming was done on it originally.Not fat anymore. Need to get better at golf now!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
cutting down a driver shaft for a 3 wood
By jeffc in forum Club Making & ComponentsReplies: 1Last Post: 11-04-2012, 08:11 PM -
Driver Shaft vs. 3 Wood Shaft
By quinner in forum Club Making & ComponentsReplies: 1Last Post: 06-16-2010, 01:09 PM -
Would a wood shaft be the same as a driver shaft (fitting)
By sillywilly in forum Club Making & ComponentsReplies: 5Last Post: 05-27-2008, 12:10 PM -
Driver shaft in a 3 wood?
By northern33 in forum Club Making & ComponentsReplies: 13Last Post: 09-25-2006, 10:00 PM -
Driver/Fairway wood shaft
By mcgoo in forum Components & ToolsReplies: 0Last Post: 04-15-2006, 06:31 PM