+ Reply to Thread
Results 1 to 3 of 3
Thread: Switching TM adapters
-
05-24-2013 03:00 PM #1
Switching TM adapters
Got a quick question,
I have a matrix f6m2 shaft that I love, but I'm looking to upgrade from the R11S to the R1. If I buy the R1 adapter from golfsmith, is it relatively easy to remove the R11S tip and install the R1 adapter?
I have a heat gun, epoxy and club vise.
Thanks
-
05-25-2013 08:10 AM #2
- Join Date
- Dec 2008
- Location
- Ottawa
- Posts
- 620
Yes it's fairly easy to do. But just an FYI the R1 ferrule that is on the R1 will melt once heat is applied, for some reason it's a lot softer than the R11s version and does not hold up. But doesn't sound like that will matter as you're purchasing an after-market version.
-
05-25-2013 10:24 AM #3
Thanks for the reply. Ya I'm gonna buy a R1 and R11S adapter from golf works just in case they melt on removal.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
910 Shafts with Adapters
By jeffc in forum Components & ToolsReplies: 7Last Post: 08-10-2012, 01:22 PM -
Taylor made shafts with adapters
By BOB LEFEBVRE in forum Components & ToolsReplies: 1Last Post: 05-22-2011, 04:21 PM -
I-Mix Adapters
By duhast in forum Club Making & ComponentsReplies: 3Last Post: 09-22-2009, 02:32 PM -
Switching Shafts
By Silversnake in forum Club Making & ComponentsReplies: 6Last Post: 06-07-2007, 11:54 AM -
Switching Balls
By BG458 in forum Rules Of GolfReplies: 6Last Post: 05-20-2005, 11:50 PM