+ Reply to Thread
Results 1 to 3 of 3
-
04-03-2013 02:54 PM #1
Swapping shafts from TM to Titleist adapter?
I have an R9 driver shaft that I would like to try in my new 910 head. Is it as straight forward as pulling the TM adapter and installing the new Titleist adapter? Will I need to trim anything? I assume that it is that simple, but I have been wrong before.
Thanks
-
04-06-2013 11:18 PM #2
- Join Date
- Dec 2008
- Location
- Ottawa
- Posts
- 620
It can be just that simple. If the weight of the two shafts are close (+/-1g), chances are they will swing-weight out fine without the need to adjust. That being said, if one is lighter or heavier, Titleist sells additional weights for their drivers specifically for swing-weighting. As for trimming, the shafts should have been done prior to their original install and therefore should not need anything extra done.
-
04-07-2013 11:43 PM #3
Thanks, that makes sense. I will put the two shafts on the scale and see how they match.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Titleist adapter
By BOB LEFEBVRE in forum Components & ToolsReplies: 1Last Post: 04-01-2013, 07:00 PM -
Titleist OEM .370 Surefit Adapter
By sabzor in forum Components & ToolsReplies: 1Last Post: 03-02-2013, 11:20 AM -
Titleist 910 Adapter for driver
By jeffc in forum Other Golf AdsReplies: 3Last Post: 04-13-2012, 11:05 AM -
OEM Titleist 910 Adapter
By racmbs in forum Components & ToolsReplies: 2Last Post: 02-13-2012, 11:45 AM -
Swapping Graphite For Steel
By Big Johnny69 in forum Club Making & ComponentsReplies: 10Last Post: 04-11-2011, 10:52 PM