+ Reply to Thread
Results 1 to 7 of 7
Thread: Nike Irons Hosel size
-
02-12-2005 02:50 PM #1
Nike Irons Hosel size
I tried to find the answer for this on the nikegolf.com site, no luck. Does anyone know what size shaft Nike iron hosels take, taper or parallel? Thanks in advace.
-
02-12-2005 03:43 PM #2
Which model?
When applying the Rules, you follow them line by line. You don't read between them.
-
02-13-2005 10:10 AM #3
I assumed they were all the same. The Pro Combos are the ones I need. Cheers.
-
02-13-2005 11:03 AM #4
http://www.golfsmith.com/cm/pdf/oem_replacement.pdf
Most OEM go with taper tip irons. The main reason: production. Not because they are any better.
No tip trimming whatsoever. The shafts come in pre trimmed.Last edited by Chieflongtee; 02-13-2005 at 05:32 PM.
-
02-13-2005 11:23 AM #5
Thank you Andre. This table is interesting to look at. I was surpised that the recommended SS for the TT DGS300 is only 80-90 mph. I always thought it was higher, around 90-100.
-
02-13-2005 12:51 PM #6
I' d have to check.Different strokes for different folks.
http://www.dowswell.net/customgolf/s...ting-guide.htm
-
02-13-2005 05:38 PM #7Originally Posted by jbrace
Or you may determine swing speed by correlating it to your shot carry distance with a driver or a 5-iron (see chart below). This is a slightly less reliable method of obtaining swing speed, but will work for most golfers. Once you've determined your swing speed (driver speed for wood shafts; 5-iron speed for iron shafts), apply them to the shaft specs chart and make the sure the shaft (and flex) you select has a RSSR that matches your swing speed.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Nike SQ 5000 Driver Hosel Question
By eyeping in forum Club Making & ComponentsReplies: 2Last Post: 07-16-2010, 07:27 AM -
Hosel size for ta2?
By buykrux in forum Club Making & ComponentsReplies: 2Last Post: 11-10-2008, 02:01 PM -
.350 Hosel size options...
By John in forum Club Making & ComponentsReplies: 8Last Post: 10-30-2008, 08:34 AM -
hosel pin on Macgregor irons
By Rick_Kane in forum Club Making & ComponentsReplies: 2Last Post: 07-22-2008, 06:37 PM -
KZG CH1 Hosel Size
By Golfbum in forum Club Making & ComponentsReplies: 1Last Post: 02-19-2006, 07:25 AM