+ Reply to Thread
Results 1 to 7 of 7
Thread: Prolaunch Red 3 Wood trimming
-
06-03-2012 05:04 PM #1
Prolaunch Red 3 Wood trimming
I have a prolaunch red that I purchased to use in my driver. It has an R9 tip and the shaft was not tipped when the tip was installed. I want to try it in my 3 wood, can I just remove the grip and butt trim it to the right length?
Thanks
-
06-03-2012 08:08 PM #2
Yes Denis just butt trim it to length
-
06-04-2012 10:09 AM #3
-
06-09-2012 10:36 AM #4
The recommended tipping for a Prolaunch Red is 1/2" for a 3 wood. So keep that in mind.
[FONT=System][COLOR=DarkRed]
[/COLOR][/FONT]
-
06-09-2012 01:16 PM #5
Okay, so if I don't remove the R9 tip and tip trim 1/2" what will that do to the playing characteristics? Make the tip softer resulting in a higher ball flight? I was planning on just trimming the butt.
-
06-09-2012 02:54 PM #6
Yes, it will play softer and should play accordingly. I take its going into a TM FCT head.
I'd suggest trying as is but leave 1/2" in case its too soft so you can tip trim after it if need be. Try it out choke up, then if you like how the flex plays butt trim that extra 1/2". or you could butt trim to length and if you find it too soft tip trim and extend it. I prefer the first so you don't have to deal with extensions - i'm not a fan of them.[FONT=System][COLOR=DarkRed]
[/COLOR][/FONT]
-
06-09-2012 03:30 PM #7
Its going into an R9 3 wood and currently the shaft is setup up to play in an R9 Supertri driver. I'll give a trim and maybe leave the 1/2 inch and then see how it feels. Thanks for your help.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
TM R9, R11, FCT tip trimming protocol
By stone_bone in forum Club Making & ComponentsReplies: 0Last Post: 03-23-2012, 12:43 PM -
Trimming Shaft from tip end??
By davevandyk in forum Club Making & ComponentsReplies: 2Last Post: 02-28-2012, 11:39 AM -
butt trimming Project X shafts...
By gdwlkspld in forum Club Making & ComponentsReplies: 11Last Post: 04-09-2009, 11:20 PM -
Tip trimming foe excelsior shaft
By challengegolf in forum Club Making & ComponentsReplies: 12Last Post: 04-25-2007, 07:10 AM -
Tip Trimming
By Stephen in forum Club Making & ComponentsReplies: 5Last Post: 01-18-2007, 12:39 AM