Golf Tees for Sensor pads

[psace]

I am wondering if anyone has found the ideal tee for sensor pad based simulators with rubber tee holders?

I am looking for one that doesn't break and won't fly out of the tee holder. I currently use the Brush T golf tee but it will occasionally come out of the holder and cause unwanted shot detection.

[bubba22]

I use the brush T as well. Get the extra long one. They seem to stay in the holder better.

[ZMax]

http://www.golfsmith.com/product/300...rds-more-3-1-4

I'm using these now. They will fly off occasionally but I haven't seen any problems.

[syhlif32]

http://www.golfsmith.com/product/300...rds-more-3-1-4

I'm using these now. They will fly off occasionally but I haven't seen any problems.

I use the same ones and also like them.
Good you came up with this post as I need to remember to buy more of them. Our cat likes them too.

[CPA]

Any chance you can buy and use the truestrike rubber holder and tees, 2 lengths and they have a knob on the end so dont come out.

[ZMax]

I have some of those plastic tees CPA. They do stay in but will break off after a few swings because they don't bend like the ones I posted.

[psace]

Thanks for all the suggestions.

I do use the long Brush T but you have to make sure it is all the way in the tee holder.

I will try the ones from Golfsmith very soon.

I was wondering about the tees from Customdesigngolf with the knobs on the end but if they break then those ones are out. Nothing worse than having to look for your needlenose pliers to pull out the broken end!

[ZMax]

Yes, they break.