+ Reply to Thread
Results 1 to 2 of 2
Thread: Ferrule for TM irons
-
03-19-2012 12:01 PM #1
Ferrule for TM irons
Hey guys, I am planning to install a set of PX 5.5s into my new TaylorMade MC/MBs and want to make sure I buy the correct ferrules that fit.
I know they are .335, but I want to make sure they fit on the OD
thanks
-
03-19-2012 12:45 PM #2
Golfworks lists the OD of all there ferrules. If you've got calipers just measure the hosel on the clubs and you are good to go.
It is best to get a ferrule that is a little oversized so that you can turn it down after the fact to get a perfectly flush fit.Not fat anymore. Need to get better at golf now!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
I-Mix Adaptor w/ Original Ferrule
By H-Bear in forum Components & ToolsReplies: 0Last Post: 08-24-2010, 03:37 PM -
What is prepping and what is a ferrule
By "Richard" in forum Club Making & ComponentsReplies: 6Last Post: 04-19-2006, 09:08 PM -
Ferrule question
By Big Johnny69 in forum Club Making & ComponentsReplies: 8Last Post: 04-07-2006, 05:24 PM -
Poor man's ferrule turner?
By rockford35 in forum Club Making & ComponentsReplies: 4Last Post: 11-04-2005, 12:18 PM -
Ferrule questions...
By rockford35 in forum Club Making & ComponentsReplies: 21Last Post: 11-01-2005, 09:58 AM