+ Reply to Thread
Results 1 to 4 of 4
Thread: Question on Shafts
-
07-28-2010 09:17 AM #1
- Join Date
- Jul 2010
- Location
- Gatineau
- Posts
- 66
Question on Shafts
What would be the best shaft for a lower trajectorie ball flight?
i have a swing speed over 110 and i hit the ball fairly high with too much spin!
So i'm looking at something to lower the ball and take the spin off!
-
07-28-2010 09:29 AM #2
- Join Date
- Feb 2005
- Location
- Forever stuck between single digit and trunk slammer!
- Posts
- 16,809
Aldila ProtoPype. One of the lowest launching and lowest spinning shafts out there. And it just so happens I have one.
But other than that, you'd want to look for a shaft that is very tip stiff. Those types of shaft tend to bring the ballflight down."A life lived in fear of the new and the untried is not a life lived to its fullest." M.Pare 10/09/08
-
07-28-2010 06:16 PM #3
- Join Date
- Dec 2005
- Location
- Stittsville
- Posts
- 1,512
Check the specs on the driver head you are using. You can reduce the spin a whole lot more with the proper head design for your swing than you can with a shaft change.
Less loft and/or more weight forward heads will rectify the problem.
-
07-29-2010 01:21 PM #4
- Join Date
- Jul 2008
- Location
- Pembroke
- Posts
- 203
Rombax / whiteboard / project x all low launch / low spin.
I am a lower launcher but higher swing speed 118. Current play proforce v2 67g xflex in a Supertri. Gives me mid-launch conditions that I like. Tried the whiteboard 83g, could barely clear a tee block. That shaft launches looooooooow.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question Regarding Mercury Shafts
By Golfbum in forum Club Making & ComponentsReplies: 2Last Post: 11-07-2005, 07:07 PM -
Question about pured/spined shafts?
By Big Johnny69 in forum Club Making & ComponentsReplies: 36Last Post: 10-14-2005, 10:12 PM -
Question on shafts
By RobC in forum Golf ClubsReplies: 1Last Post: 02-14-2003, 12:51 PM -
Question on shafts
By RobC in forum Golf ClubsReplies: 0Last Post: 02-13-2003, 03:18 PM -
Question on shafts
By RobC in forum General Golf TalkReplies: 0Last Post: 02-13-2003, 02:58 PM