+ Reply to Thread
Results 1 to 4 of 4
-
07-08-2010 01:46 PM #1Bill WoodGuest
.335 driver shaft a little big for Driver Head
I've got a Nakashima High loft ladies driver head and I'm fitting it with a .335 tip which I thought was really bang on. Now I find that the .335 tip is just a little large for this driver head. I've cleaned the head out well - and really don't want to bore the Nak hosel. I really can't figure this one out. Anybody run across a hosel in a driver that a .335 does not fit. Especially in a Nak head ? Go figure. I don't want to shave done the .335 tip - and don't want to chew anything out of the hosel. I've check my measurements and tipping etc. I'm out of ideas.
-thanks all-
-
07-08-2010 02:41 PM #2
Have you measured the shaft/hosel in question with calipers?
Every now and then I come across either a head that has an undersized hosel or a shaft that is slightly oversized.
For a graphite shaft just sand down the tip until it fits. Similarly you can enlarge the hosel slightly with sandpaper (it's a tedious process) until it fits.Not fat anymore. Need to get better at golf now!
-
07-08-2010 03:07 PM #3Bill WoodGuest
-
07-08-2010 03:08 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Integra Sooo Long driver head 10.5 loft 175 gram head
By Chieflongtee in forum Right Hand DriversReplies: 1Last Post: 11-22-2012, 09:03 AM -
Nike Vr Driver, Voodoo Aldilla stiff shaft, head cover and wrench
By cokelon in forum Right Hand DriversReplies: 3Last Post: 09-29-2011, 08:11 PM -
Driver head and Tour issue Shaft
By wings in forum Components & ToolsReplies: 6Last Post: 04-03-2008, 07:44 AM -
Driver head slipping down on the shaft...
By BredStik in forum Golf ClubsReplies: 3Last Post: 08-22-2006, 03:20 PM -
bore through shaft in a reg driver head... can it be done??
By "Richard" in forum Club Making & ComponentsReplies: 7Last Post: 06-01-2006, 10:01 PM