+ Reply to Thread
Results 1 to 2 of 2
-
03-19-2010 01:36 PM #1
- Join Date
- Jun 2003
- Location
- Pine Arbour Estates, Port Elmsley
- Posts
- 7,893
Nickent 4DX Evolver interchangeable shafts
Hi, I have the 4DX Evolver driver with 2 interchangeable shafts. These shafts come with the hosel adapter epoxied to the shaft. I have a CYG hosel that I wish to install on one of my current 4DX shafts. I was wondering if there is any way to remove the current adapter to not damage it other than using low heat and trying to remove it with a leather glove?
J-LLefty Lucas
I am abidextrous, I once golfed right-handed and now I shoot left-handed just as badly!
-
03-19-2010 09:48 PM #2
- Join Date
- Jun 2003
- Location
- Pine Arbour Estates, Port Elmsley
- Posts
- 7,893
Actually I removed the plastic ferrule and the sleeve was easily removed with my shaft puller and is ready to be installed on another shaft!! Cleaned the shaft and installed the CYG adapter. Now its ready to go and I can benefit from 26 different settings, open or close the face, increase loft ...all in about a minute.
Lefty Lucas
I am abidextrous, I once golfed right-handed and now I shoot left-handed just as badly!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Nickent 4DX Evolver Driver
By CBrown in forum Right Hand DriversReplies: 0Last Post: 09-03-2011, 11:47 AM -
Nickent 4DX Evolver Driver
By fireice in forum Right Hand DriversReplies: 4Last Post: 01-30-2010, 10:44 AM -
Nickent 4DX Evolver Driver
By fireice in forum Right Hand DriversReplies: 1Last Post: 09-29-2009, 08:09 AM -
Nickent 4DX Evolver Driver
By fireice in forum Right Hand DriversReplies: 5Last Post: 07-13-2009, 08:27 AM -
Nickent 4DX Evolver CYG Shaft Tip/Shafts/Wrench
By fireice in forum Components & ToolsReplies: 0Last Post: 06-24-2009, 01:39 AM