+ Reply to Thread
Results 1 to 3 of 3
Thread: help needed - looking for wedges
-
09-03-2009 10:27 AM #1
- Join Date
- Jul 2009
- Location
- Gatineau
- Posts
- 277
help needed - looking for wedges
hey,
so i have a wilson di7 iron set that's 4-gw. there was a sand and lob wedge available in this set but wilson doesnt have any anymore. id really like to locate these two clubs for the full set. anyone have any suggestions besides looking on ebay?
thanks,
jon
-
09-03-2009 09:50 PM #2
- Join Date
- May 2005
- Location
- Chelsea
- Posts
- 338
Have you considered using wedges other than Wilson? There are lots of wedges that might be, for you, better than the Wilson's you are looking at. Wedges do not need to match your set. You don't swing a wedge like you swing an iron.
-
09-04-2009 08:33 AM #3
- Join Date
- Jul 2009
- Location
- Gatineau
- Posts
- 277
yip, i sure have and will if i have to.. but id like to get these because 1) the di series uses one less degree of loft on each iron in the set and would like to keep it consistent and 2) i already have the gap and pitching wedges from this set and would like to keep it all together.
since its so close to end of season ill ride it out till next spring and see what happens.. might find one here or on the bay.
i also got ahold of wilson yesterday and they say they may be able to get their hands on some raw materials and make them for me.. they'll let me know next tuesday..
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
10-12 capper needed now
By Mattchew in forum Arrange a GameReplies: 9Last Post: 10-07-2008, 09:33 AM -
8 capper needed
By Mattchew in forum Arrange a GameReplies: 60Last Post: 09-29-2008, 08:44 PM -
Clerical Help Needed
By Hacker in forum Business NetworkingReplies: 9Last Post: 05-15-2008, 01:39 PM -
NEEDED - Drywaller
By jman in forum Other StuffReplies: 1Last Post: 04-11-2006, 09:24 PM -
Tip needed: trajectory...
By golfman71 in forum InstructionReplies: 8Last Post: 03-23-2003, 03:12 PM