+ Reply to Thread
Results 1 to 4 of 4
Thread: Shaft Question
-
08-26-2009 04:37 PM #1
- Join Date
- Aug 2009
- Location
- Ottawa
- Posts
- 22
Shaft Question
I play a draw but I find when I really want to swing my driver I play a huge high draw. My miss is a hook, but I find that even on good contact when I give a good swing I will get 275 almost all of it carry with a draw that plays from the right side of the fairway to the left. This is good distance and carry for me but it is very annoying to control, and the height makes it difficult to play in the wind. I am currently using a Grafalloy prolaunch blue stiff shaft. I don't consider my swing speed too high, and (finally) my question is are there other shafts out there that might be a better fit?
-
08-27-2009 10:58 PM #2
- Join Date
- May 2009
- Location
- The Garrison
- Posts
- 48
could be anything buddy, a swing tendency, wrong shaft, even wrong flex. Get fitted is my advice!
-
08-28-2009 07:38 AM #3
- Join Date
- Feb 2004
- Posts
- 4,163
A ball that starts right of the target line and ends left of the target line is a HOOK. The good news is that the path of your club head is from the inside and the bad news is that the club face is a little closed at separation instead of being slightly open, a position that produces a pure draw. Solution: Turn your left hand left a little (assume right handed). The ball should now end up in the middle.
While your angle of attack may be a little too upward, a golf shaft with a stiffer tip section may lower the ball flight a little. Your shaft is of "average" tip stiffness. The Aldila NV 65 "X" or 75 "S" are examples of shafts that provide a stiffer tip section. However, I would make the simple grip and swing adjustments first, rather than possibly waste time and money on shafts.
-
08-28-2009 01:25 PM #4
- Join Date
- Aug 2009
- Location
- Ottawa
- Posts
- 22
Sounds good, I better hit the range. I've often played around with ball placement and tried not to take the club way inside...maybe the grip is the key
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question - Shaft
By Kozmo in forum Club Making & ComponentsReplies: 12Last Post: 06-16-2010, 07:14 AM -
Shaft question
By Gropper in forum Club Making & ComponentsReplies: 3Last Post: 12-04-2008, 10:09 PM -
Shaft Question
By quinner in forum Club Making & ComponentsReplies: 2Last Post: 11-24-2008, 12:28 PM -
shaft question
By Mattchew in forum Club Making & ComponentsReplies: 3Last Post: 06-04-2007, 07:42 PM -
Shaft question?
By Big Johnny69 in forum Club Making & ComponentsReplies: 10Last Post: 06-02-2006, 08:37 AM