Results 1 to 6 of 6
Thread: replacing steel shafts
Threaded View
-
04-13-2004 04:32 PM #1
- Join Date
- Apr 2004
- Location
- Ottawa
- Posts
- 15
replacing steel shafts
I have a set of Taylor Made 300 Forged irons with Precision Rifle Flighted 6.0 steel shafts. I find them a little too stiff as I am hitting them about a half club shorter then my previous clubs (which had a regular flex shaft in them). I purchased some Precision Rifle 5.0 steel shafts online and I was planning to make the switch to these. However, I didn't realize when I bought them that there was a difference between tapered and parallel tipped shafts. The new shafts I have bought are parallel tip and I am pretty sure that my TM 300's are tapered.
I was told that you can still put a parallel tip into a tapered tip club head by doing just a little bit of drilling. Has anyone done this before? Is the drilling likely to affect the structural integrity of the golf club? I don't plan on doing this myself, but I just wanted to get an opinion before I take it into a store to get it done.
Thanks in advance for any insight.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Looking for TP x-100 steel shafts
By slamdedam in forum Components & ToolsReplies: 4Last Post: 10-21-2011, 11:12 AM -
Replacing Grips
By cokelon in forum Club Making & ComponentsReplies: 4Last Post: 09-09-2011, 11:25 AM -
TM S90 Steel Shafts
By Big Johnny69 in forum Components & ToolsReplies: 0Last Post: 10-11-2010, 03:02 PM -
Replacing X-14 steel shafts
By leftylucas in forum Club Making & ComponentsReplies: 2Last Post: 05-31-2005, 09:40 AM -
difference between stiff steel and regular steel shafts?
By Dustin in forum General Golf TalkReplies: 7Last Post: 06-08-2003, 03:10 PM