+ Reply to Thread
Results 1 to 1 of 1
Thread: Rawing Clubheads
-
12-14-2008 10:03 PM #1
Rawing Clubheads
I know there were many discussing about this in the past, just wondering if anybody had found a place in Canada that would do it.
I know that people say just go to an automotive shop, etc. but was curious if anybody has actually gone ahead and done it?? I have a set of Bridgestone J33 blades that I have been dying to get done, or even gunmetal, but don't want to deal with the cost and time of sending to the states.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stamping Clubheads
By John in forum Club Making & ComponentsReplies: 1Last Post: 01-06-2011, 11:25 PM -
new, discontinued iron clubheads...what to do with them??
By sailer in forum Club Making & ComponentsReplies: 2Last Post: 10-18-2010, 07:12 PM -
Anybody on here refinish clubheads?
By shovellover in forum Club Making & ComponentsReplies: 3Last Post: 05-17-2007, 08:57 PM -
Who paints clubheads?
By Ginker in forum Golf ClubsReplies: 1Last Post: 11-19-2006, 10:12 PM