+ Reply to Thread
Results 1 to 5 of 5
-
11-29-2008 09:14 AM #1
Sticky suggestion-shaft replacement guide
Sticky suggestion-shaft replacement guide
http://golfworks.com/article.asp_Q_ai_E_376
http://www.golfsmith.com/pdf/oem_replacement.pdfLive as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
12-07-2008 09:07 PM #2
- Join Date
- Jan 2008
- Location
- Mason, Ohio
- Posts
- 68
Heck, I was lookin for Tommy Armour and Nada. Any idea what the hosel dia. on TA Silver Scot Forged is?
Not much on signatures eh ?
-
12-07-2008 09:28 PM #3
If you have the clubs in your possession:
A little trick from forum member eyeping
In the future if you use a 3/8" open end wrench and place it just over the ferrule and run it toward the first step, if it will not go all the way to the step you have a taper shaft and in most cases if it goes up to the step it is a parallel tip. Great trick if you want to know without removing the shaftLive as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
12-07-2008 09:32 PM #4
- Join Date
- Jan 2008
- Location
- Mason, Ohio
- Posts
- 68
-
12-08-2008 05:17 PM #5
Almost forgot. If the previous trick does not work and you're dealing with True Temper just compare the step pattern:
http://truetemper.com/golf/identify.aspLive as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
OEM shaft guide?
By Gurk in forum Club Making & ComponentsReplies: 2Last Post: 07-18-2011, 09:33 AM -
FT-5 shaft replacement
By leftylucas in forum Club Making & ComponentsReplies: 8Last Post: 09-15-2008, 08:30 AM -
Shaft replacement guide
By Chieflongtee in forum Club Making & ComponentsReplies: 2Last Post: 01-13-2007, 11:07 AM -
2006 Shaft Fitting Addendum and the The Modern Guide To Shaft Fitting.
By Chieflongtee in forum Club Making & ComponentsReplies: 2Last Post: 01-10-2007, 03:21 PM -
shaft suggestion
By kennedyk in forum Club Making & ComponentsReplies: 6Last Post: 07-31-2006, 05:52 PM