Ping G10 for another G10 or G5 - desire shaft change

[3Jack]

Looking to trade my nearly new Ping G10 9 degree driver (used five rounds), has not seen the range. No sky marks. Pristine TFC 129 stiff shaft, trimmed 1/4 inch from standard.

Looking for a G5, either 9 or 10.5 degrees, with a Aldila NV 65 stiff shaft, or another G10 with the TFC 129 stiff shaft at 10.5 degrees.

[rezadue]

PM Sent.

Looking to trade my nearly new Ping G10 9 degree driver (used five rounds), has not seen the range. No sky marks. Pristine TFC 129 stiff shaft, trimmed 1/4 inch from standard.

Looking for a G5, either 9 or 10.5 degrees, with a Aldila NVS stiff shaft, or another G10 with the TFC 129 stiff shaft at 10.5 degrees.

[Drew]

PM sent

[3Jack]

Note the revised shaft spec in the original post. My bad.

[gdwlkspld]

3-J:

Was that 1/4 " trimmed from the butt? Any idea of the swing weight?

I have a 10.5 G10 with the TFC129 stiff shaft that has been used for about 10 rounds.

No dings, sky marks etc.

I might be interested in a slightly lower launch...

[3Jack]

Factory trimmed from the butt, yes. Still plays to a D2.

[mcgoo]

I have G10 with the TFC 129 reg. shaft at 10.5 degrees, no headcover, $225.

[3Jack]

Thanks mcgoo, but I'm in need of a stiff shaft.

[3Jack]

3-J:

Was that 1/4 " trimmed from the butt? Any idea of the swing weight?

I have a 10.5 G10 with the TFC129 stiff shaft that has been used for about 10 rounds.

No dings, sky marks etc.

I might be interested in a slightly lower launch...

PM sent.

[Thunder]

I have a G5 with a V2 stiff. LMK

[boud man]

pm sent

[Thunder]

Any feeling on the G5 ???

[MixBag]

still have the g5 with a stiff and x-stiff shaft, h/c included.

[3Jack]

still have the g5 with a stiff and x-stiff shaft, h/c included.

Ok, thanks MixBag. I am in touch with someone regarding a possible exchange, so I'll let you know if that doesn't work out. Thanks!

[3Jack]

No longer looking to trade at this time. Thanks everyone...