+ Reply to Thread
Results 1 to 8 of 8
Thread: wedge bending.
-
03-17-2007 11:10 AM #1
wedge bending.
thinking about doing a little bending job on my rac wedges. this can be done on these wedges right? and does anybody know if golf town does this, and what they charge per club/degree etc.. ? (junior) thanks alot.
-
03-17-2007 11:24 AM #2
Before you do so can I ask you why? Have you done any dynamic lie testing? Anyway most places charge between $3 to $5 per club. Couple clubmakers on this forum can perform the task for you.Are your wedges satin?
Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
03-17-2007 11:37 AM #3
I just wrote them and will post the results once they answer back.
Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
03-17-2007 11:50 AM #4
okay thanks cheif.
the reason i was thinking about bending, was because the pw in my new iron set (ta2s) is 46*, and i dont want a pw-gw gap, so i was thinking of bending my 52,56 racs to 50/54. i know the will go from 8 and 12 bounce, to 6 and 10. good idea or not?
thanks again,
Craig.
-
03-17-2007 11:57 AM #5
-
03-17-2007 12:07 PM #6
i forget what GT charges i think $4? or something like that. and yes call GT and ask for Jaime he can do it for you no problem, hes bent every wedge ive ever owned
-
03-17-2007 12:51 PM #7Live as if you were to die tomorrow. Learn as if you were to live forever.
Mahatma Gandhi
-
03-17-2007 05:15 PM #8
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Putter Bending machine with bending bar
By taboo in forum Components & ToolsReplies: 1Last Post: 11-28-2010, 01:20 PM -
link to wedge bending thread
By jeffc in forum Club Making & ComponentsReplies: 1Last Post: 06-17-2010, 09:33 AM -
Bending a Rac 56* Help!
By sebber in forum Golf ClubsReplies: 6Last Post: 05-01-2009, 07:43 PM -
Bending Woods?
By MusicMan in forum Club Making & ComponentsReplies: 2Last Post: 03-12-2007, 04:29 PM -
Bending a 54* Wedge
By Hacker in forum Club Making & ComponentsReplies: 9Last Post: 08-10-2006, 06:05 PM